Model |
RUTX09 |
Xuất xứ |
EU |
Mobile module |
4G (LTE) – Cat 6 up to 300 Mbps, 3G – Up to 42 Mbps |
SIM switch |
2 SIM cards, auto-switch cases: weak signal, data limit, SMS limit, roaming, no network, network denied, data connection fail |
Status |
Signal strength, SINR, RSRP, RSRQ, Bytes sent/received, connected band, carrier aggregation, IMSI, ICCID |
SMS |
SMS status, SMS configuration, send/read SMS via HTTP POST/GET, Email to SMS, SMS to Email, SMS to HTTP, SMS to SMS, SMS auto reply |
USSD |
Supports sending and reading Unstructured Supplementary Service Data messages |
Black/White list |
Operator black/white list |
Multiple PDN |
Possibility to use different PDNs for multiple network access and services |
Band management |
Band lock, Used band status display |
APN |
Auto APN |
Bridge mode |
Direct connection (bridge) between mobile ISP and device on LAN |
ETHERNET |
|
WAN |
1 x WAN port (can be configured as LAN) 10/100/1000 Mbps, compliance with IEEE 802.3, IEEE 802.3u, 802.3az standards, supports auto MDI/MDIX crossover |
LAN |
3 x LAN ports, 10/100/1000 Mbps, compliance with IEEE 802.3, IEEE 802.3u, 802.3az standards, supports auto MDI/MDIX crossover |
NETWORK |
|
Routing |
Static routing, Dynamic routing (BGP, OSPF v2, RIP v1/v2, EIGRP, NHRP) |
Network protocols |
TCP, UDP, IPv4, IPv6, ICMP, NTP, DNS, HTTP, HTTPS, FTP, SMTP, SSL v3, TLS, ARP, VRRP, PPP, PPPoE, UPNP, SSH, DHCP, Telnet client, SNMP, MQTT, Wake on LAN (WOL) |
VoIP passthrough support |
H.323 and SIP-alg protocol NAT helpers, allowing proper routing of VoIP packets |
Connection monitoring |
Ping Reboot, Wget reboot, Periodic Reboot, LCP and ICMP for link inspection |
Firewall |
Port forwards, traffic rules, custom rules |
DHCP |
Static and dynamic IP allocation, DHCP Relay, Relayd |
QoS / Smart Queue Management (SQM) |
Traffic priority queuing by source/destination, service, protocol or port |
DDNS |
Supported >25 service providers, others can be configured manually |
Network backup |
VRRP, Mobile and Wired WAN options, each of which can be used as an automatic Failover |
Load balancing |
Balance Internet traffic over multiple WAN connections |
Hospot |
Internal/external Radius server, captive portal, built in customizable landing page |
SSHFS |
Possibility to mount remote file system via SSH protocol |
SECURITY |
|
Authentication |
Pre-shared key, digital certificates, X.509 certificates |
Firewall |
Pre-configured firewall rules can be enabled via WebUI, unlimited firewall configuration via CLI; DMZ; NAT; NAT-T |
Attack prevention |
DDOS prevention (SYN flood protection, SSH attack prevention, HTTP/HTTPS attack prevention), port scan prevention (SYN-FIN, SYN-RST, X-mas, NULL flags, FIN scan attacks) |
VLAN |
Port and tag based VLAN separation |
Mobile quota control |
Custom data limits for both SIM cards |
WEB filter |
Blacklist for blocking out unwanted websites, Whitelist for specifying allowed sites only |
Access control |
Flexible access control of TCP, UDP, ICMP packets, MAC address filter |
VPN |
|
OpenVPN |
Multiple clients and a server can run simultaneously, 12 encryption methods |
OpenVPN Encryption |
DES-CBC, RC2-CBC, DES-EDE-CBC, DES-EDE3-CBC, DESX-CBC, BF-CBC, RC2-40-CBC, CAST5-CBC, RC2-64-CBC, AES-128-CBC, AES-192-CBC, AES-256-CBC |
IPsec |
IKEv1, IKEv2, with 5 encryption methods for IPsec (DES, 3DES, AES128, AES192, AES256) |
GRE |
GRE tunnel |
PPTP, L2TP |
Client/Server instances can run simultaneously, L2TPv3 support |
Stunnel |
Proxy designed to add TLS encryption functionality to existing clients and servers without any changes in the program’s code |
DMVPN |
Method of building scalable IPsec VPNs |
SSTP |
SSTP client instance support |
ZeroTier |
ZeroTier VPN client support |
WireGuard |
WireGuard VPN client and server support |
MODBUS TCP SLAVE |
|
ID filtering |
Respond to one ID in range [1;255] or any |
Allow remote access |
Allow access through WAN |
Custom registers |
MODBUS TCP custom register block, which allows to read/write to a file inside the router, and can be used to extend MODBUS TCP slave functionality |
MODBUS TCP MASTER |
|
Supported functions |
01, 02, 03, 04, 05, 06, 15, 16 |
Supported data formats |
8 bit: INT, UINT; 16 bit: INT, UINT (MSB or LSB first); 32 bit: float, INT, UINT (ABCD (big-endian), DCBA (little-endian), CDAB, BADC), HEX, ASCII |
MQTT GATEWAY |
|
Gateway |
Allows sending commands and receiving data from MODBUS Master through the MQTT broker |
DNP3 |
|
Supported modes |
TCP Master, DNP3 Outstation |
DATA TO SERVER |
|
Protocols |
HTTP(S), MQTT, Azure MQTT, Kinesis |
MONITORING & MANAGEMENT |
|
WEB UI |
HTTP/HTTPS, status, configuration, FW update, CLI, troubleshoot, event log, system log, kernel log |
FOTA |
Firmware update from server, automatic notification |
SSH |
SSH (v1, v2) |
SMS |
SMS status, SMS configuration, send/read SMS via HTTP POST/GET, EMAIL to SMS, SMS to Email, SMS to HTTP, SMS to SMS, SMS autoreply |
Call |
Reboot, Status, Mobile data on/off, Output on/off |
TR-069 |
OpenACS, EasyCwmp, ACSLite, tGem, LibreACS, GenieACS, FreeACS, LibCWMP, Friendly tech, AVSystem |
MQTT |
MQTT Broker, MQTT publisher |
SNMP |
SNMP (v1, v2, v3), SNMP trap |
JSON-RPC |
Management API over HTTP/HTTPS |
MODBUS |
MODBUS TCP status/control |
RMS |
Teltonika Remote Management System (RMS) |
SYSTEM CHARACTERISTICS |
|
CPU |
Quad-core ARM Cortex A7, 717 MHz |
RAM |
256 MB, DDR3 |
FLASH storage |
256 MB, SPI Flash |
FIRMWARE / CONFIGURATION |
|
WEB UI |
Update FW from file, check FW on server, configuration profiles, configuration backup |
FOTA |
Update FW/configuration from server |
RMS |
Update FW/configuration for multiple devices at once |
Keep settings |
Update FW without losing current configuration |
FIRMWARE CUSTOMIZATION |
|
Operating system |
RutOS (OpenWrt based Linux OS) |
Supported languages |
Busybox shell, Lua, C, C++ |
Development tools |
SDK package with build environment provided |
LOCATION TRACKING |
|
GNSS |
GPS, GLONASS, BeiDou, Galileo and QZSS |
Coordinates |
GNSS coordinates via WebUI, SMS, TAVL, RMS |
NMEA |
NMEA 0183 |
Server software |
Supported server software: TAVL, RMS |
Geofencing |
Configurable multiple geofence zones |
USB |
|
Data rate |
USB 2.0 |
Applications |
Samba share, USB-to-serial |
External devices |
Possibility to connect external HDD, flash drive, additional modem, printer |
Storage formats |
FAT, FAT32, NTFS |
INPUT/OUTPUT |
|
Input |
1 x Digital Input, 0 - 6 V detected as logic low, 8 - 30 V detected as logic high |
Output |
1 x Digital Output, Open collector output, max output 30 V, 300 mA |
Events |
SMS, Email, RMS |
I/O juggler |
Allows to set certain I/O conditions to initiate event |
POWER |
|
Connector |
4 pin industrial DC power socket |
Input voltage range |
9 – 50 VDC, reverse polarity protection, voltage surge/transient protection |
PoE (passive) |
Passive PoE. Possibility to power up through LAN port, not compatible with IEEE 802.3af, 802.3at and 802.3bt standards |
Power consumption |
9 W Max |
PHYSICAL INTERFACES |
|
Ethernet |
4 x RJ45 ports, 10/100/1000 Mbps |
I/Os |
1 x Digital Input, 1 x Digital Output on 4 pin power connector |
Status LEDs |
3 x WAN type, 2 x Mobile connection type, 5 x Mobile connection strength, 8 x LAN status, 3 x WAN status, 1x Power |
SIM |
2 x SIM slots (Mini SIM - 2FF), 1.8 V/3 V, external SIM holders |
Power |
1 x 4 pin DC connector |
Antennas |
2 x SMA for LTE, 1 x SMA for GNNS |
USB |
1 x USB A port for external devices |
Reset |
Reboot/User default reset/Factory reset button |
Other |
1 x Grounding screw |
PHYSICAL SPECIFICATION |
|
Casing material |
Aluminium housing with DIN rail mounting option |
Dimensions (W x H x D) |
115 x 44.2 x 95.1 mm |
Weight |
455 g |
Mounting options |
DIN rail, flat surface placement |
OPERATING ENVIRONMENT |
|
Operating temperature |
-40 C to 75 C |
Operating humidity |
10 % to 90 % non-condensing |
Ingress Protection Rating |
IP30 |
Đánh giá
Chưa có đánh giá nào.